On the RX Ctrl tab, choose Serial CTS and choose the correct serial port.First error message was a com port issue - seems my USB-RS232 adapter was COM 6 and Echolink was looking for COM 1 - Port reassigned, and issue settled.
How does one get that FWIW --- radio on this end is Kenwood D710 and I admit it was NOT IN SYSOP mode at the time. While awaiting responses here I will be RTFM Click to expand. If you are already on Echolink then they will approve it quickly. Then it is your call -L or -R and would be KD3NE-L Click to expand. Echolink Ham Radio Setup Download EchoLink WithoutNormally you can not download EchoLink without permission, If someone gave you a copy, it may not work. Your call may not have been verified yet, but that info should be available to you on their site. Can you log on and use echolink now I think you have it under control. Many ISPs will block incoming ports unless you pay more for it. You may want to setup the TOT in your radio, I would not rely on Echolink to replace a control operator. Enjoy. Connected to internet and all stations are listed. Sooooo. I want to test it out. I have Echolink on my iPhone and connected via cellular and NOT WIFI as the WIFI is where the SYSOP computer is located. Echolink Ham Radio Setup Crack Open TheKD3NE ( iPhone ) connected to ( KD3NE-L ) Windows Laptop710 When I crack open the squelch on the 710 I get the hash noise on my iPhone. OK so far so good. When I tune to a freq where a QSO is in process on the iPhone I get the hash noise but no audio. ECHOLINK site says to adjust audio output on rig using prog. DONE. Results still as above. REGARDING THE 710 ------ I have the Data Band setup as B Band and that is where I am doing my tuning. You can set the level also. You may have a Boost gain also, You can try it on and off, for the best setting) Are you using COS or VOX. ![]() Following the instructions in the manual, connect the cables to the two jacks in the back of the radio and to the serial port and sound card jacks of your computer. The pink plug goes to the mic input of the sound card, and the green plug goes to the line out (or speaker out). Echolink Ham Radio Setup Software Settings ForQ: For Sysop operation with the TM-V71 or TM-D710, what are the software settings for EchoLink A: Be sure EchoLink is running in Sysop mode.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |